Conley Rear Ends

[stoneyberk]

Wow yet another quickchange rear end to choose from... Let's see, As of two years ago the quickchange rear end was very hard to locate a used one,, now Conley / Quarter Mortar / LRU... At this rate they will be a dime a dozen in a few years... I haven't seen one first hand personally but i just hope all these guy's that's producing them has also beefed up the casing... It would be a shame to see these not pass go from the start...

[Mike Casey]

Those castings are very thick. The center sections are new era and they built a very heavy duty rear. I dont think there will be issues in that department...

[acc]

Whats the maximum car weight and engine HP you reckon they could handle before things go bad?

Just a rough figure out of curiosity.

[fordfreak05]

anymore updates on this rear?

how are your projects going dreambig

i pmed you .couldnt get the reply though..

[KnoxMotorsports]

When will these be ready to ship.

[Tig2]

They look great.
Any updates?

[NYCdragRacer]

Sorry to bring back such an old thread, but am I the only one that is waiting on this???

[fordfreak05]

nope...