Page 1 of 1
My PBS build
Posted: May 16th, 2016, 12:36 pm
by PTModIT
Hi, I started piecing all the parts that were in bags. Since no manual exists thanks to QSL for having photos of a PBS car, It all came together. I still need to buy some nuts and bolts and aluminum sheets for the top and bottom plates plus I need to make the front air scoop. I added a rough cut bumper today. All in all a very relaxing project.
,
,
,
,
.
Re: My PBS build
Posted: May 17th, 2016, 2:55 am
by CALracing
Nice!
Re: My PBS build
Posted: May 17th, 2016, 4:17 am
by lanegc
Looks good, can't wait to see the finished car
Re: My PBS build
Posted: May 17th, 2016, 8:32 am
by Kaye
She's a beauty!
Re: My PBS build
Posted: May 17th, 2016, 10:39 am
by Al Gibson (QSL)
looking real nice!
Re: My PBS build
Posted: May 20th, 2016, 4:46 pm
by PTModIT
It's coming along. Top and bottom plates made and installed. I haven't cut the hole or the opening for the servos. How wide is the rear wing? Thanks.
Re: My PBS build
Posted: May 26th, 2016, 12:14 pm
by PTModIT
UPDATE, I made the spacers between the clutch housing and the rear bulkhead, I made a support bracket for the refill mount, Very solid now. No flex, Also a small plate for the rear wing uprights. I bent up the side mounts for the dsus fasteners. I cut to length the side supports for the side pods. I still need to cut the holes on the top plate.
,
,
,
,
Re: My PBS build
Posted: May 27th, 2016, 1:31 am
by CALracing
looking good!
Re: My PBS build
Posted: May 29th, 2016, 10:04 am
by jean phi
Magnifique job
Re: My PBS build
Posted: June 2nd, 2016, 9:40 am
by PTModIT
Hi, I won't be updating this build anytime soon as I'm nursing my wife back to health after knee surgery.
, 
, 
, 
, 
.
