My Quickdraw sprinter

This is your place to post stories related to 1/4 scale. These could be experiences, historical stories or inside scoop of the old manufacturers!!
Post Reply
bobjeffreson
1/4 scale GOD
Posts: 687
Joined: September 7th, 2006, 9:03 pm
Location: Sydney Australia

My Quickdraw sprinter

Post by bobjeffreson »

Purchased this car some years ago and did nothing with it till last week.
Now it's ready to be displayed on the 1st of December at a show in Sydney Australia.

Image

Image

Image
bobjeffreson
1/4 scale GOD
Posts: 687
Joined: September 7th, 2006, 9:03 pm
Location: Sydney Australia

Re: My Quickdraw sprinter

Post by bobjeffreson »

vwguru75,
When the car arrived from the 'States many years ago, the frame had the motor in it, and that's all! . This week when I finally got around to rebuilding it, all I did was install the rest of the running gear, without consideration of points like you raised. The car was never going to be anything other than a show car. I always thought it was way too nice to run it on dirt, as we do down here.
So the geometry wasn't an issue. Still now that you have brought to my attention, I may well rectify that slight oversight.
Post Reply