Page 1 of 8
How to finish a gilmer midget racer
Posted: May 11th, 2017, 1:42 am
by rc garage berlin
One of my new projects. First I built every Gilmer part in 3D (except the body). I want to use an old but never run ZENOAH G2D with Tuning MRZ Cylinder head, two disc brakes at the rear axle and shocks in the front...
...just a little space left
Re: How to finish a gilmer midget racer
Posted: May 11th, 2017, 5:49 am
by Kaye
Nice.
Re: How to finish a gilmer midget racer
Posted: May 11th, 2017, 10:16 am
by bobjeffreson
Holy smoke...how good will this be.
Re: How to finish a gilmer midget racer
Posted: May 11th, 2017, 9:59 pm
by rc garage berlin
Thanks. I will post some Pictures from time to time...
Re: How to finish a gilmer midget racer
Posted: May 14th, 2017, 12:34 pm
by rc garage berlin
Yellow Parts are done...
Re: How to finish a gilmer midget racer
Posted: May 22nd, 2017, 11:11 am
by rc garage berlin
first test assembling
Re: How to finish a gilmer midget racer
Posted: May 23rd, 2017, 12:56 am
by CALracing
Sweet!
Re: How to finish a gilmer midget racer
Posted: May 24th, 2017, 2:55 am
by rc garage berlin
Does anyone knows what kind of starter connector this is and how to built it?
Re: How to finish a gilmer midget racer
Posted: June 8th, 2017, 10:26 pm
by rc garage berlin
I found a position for the gas tank or it is a problem with the centre of gravity?
Re: How to finish a gilmer midget racer
Posted: June 9th, 2017, 6:54 am
by jayhurrikane
I think thats jans custom stuff but looks like you can put a rotostart on it, or make a custom hub there that adapts to the starer wand of the roto start ya done
Really nice work there!!!!!
Re: How to finish a gilmer midget racer
Posted: June 9th, 2017, 7:57 am
by jayhurrikane
This is a rear jan made for his gilmers , was supposed to go behind a maloney100 or something suitable. It has a in out box with working lever. Its smaller than a skellenger but uses same gears and all
Re: How to finish a gilmer midget racer
Posted: June 10th, 2017, 12:58 pm
by rc garage berlin
Thank you for the helpful ideas and the pictures of the amazing rear.
Wow. Beautiful piece of art.
Re: How to finish a gilmer midget racer
Posted: June 24th, 2017, 11:00 am
by rc garage berlin
I am so happy. The zenoah fits the body perfectly without large cutouts.
Re: How to finish a gilmer midget racer
Posted: June 25th, 2017, 8:35 am
by jayhurrikane
Beautiful!
Re: How to finish a gilmer midget racer
Posted: August 2nd, 2017, 5:05 am
by Emilio
Hi Rc, hope you don't mind me posting my Gilmer here? I just got this Gilmer on ebay but haven't received it yet, should be Friday. My question is, looking at the photos from the auction, what are my options for a drivetrain?
Engine has been installed by the previous owner, it is a Zenoah g23. Or should I start over? Thanks.
Emilio