Pacesetter Funny Car

Post Reply
PaulSongas
1/4 scale guru
Posts: 246
Joined: November 12th, 2009, 9:24 am
Location: Stacy, MN

Pacesetter Funny Car

Post by PaulSongas »

Moving this project to the drag racing projects forums...

Here are the previous threads- (Original chassis, and new chassis, same body)

http://www.quarterscalelegends.com/bb/v ... =18&t=2949

http://www.quarterscalelegends.com/bb/v ... =18&t=2341


The chassis is 95% done now, I just have to work on the throttle and brake linkage to get them perfect.
Getting the body ready for paint it next.

Image

Image
NHRA # P582
PaulSongas
1/4 scale guru
Posts: 246
Joined: November 12th, 2009, 9:24 am
Location: Stacy, MN

Re: Pacesetter Funny Car

Post by PaulSongas »

Well I got it to make some nosie tonight :mrgreen: I had taken the headers off so I could have better access to the carb (fuel pick up problems) Man this thing is freaking loud! I need to put the tank and everything back in place, then I can tune it a little better. I may have to play with the getting the clutch more centered in the bell also which is going to be real fun (not) :roll:

It starts and runs now, so one more step complete.
NHRA # P582
QAman
1/4 scale guru
Posts: 145
Joined: February 28th, 2011, 7:30 pm
Location: Portland Texas

Re: Pacesetter Funny Car

Post by QAman »

Wrap the clutch shoes in 1/2 inch painters tape until it just fits inside the clutch bell. Leave a little tape hanging out. Bolt the engine and mount in place. Slowly pull the tape out. Thats what i did when i had to center mine. The blue or green painters tape pulls off easy because theres not much room there. Hope this helps. Roger.
lalacurf121
Newbie
Posts: 11
Joined: June 22nd, 2015, 8:13 pm

Re: Pacesetter Funny Car

Post by lalacurf121 »

It starts and runs now, so one more step complete.
ฮอลิเดย์ พาเลซ
Post Reply