Looking for a wheelie bar for a WCM pro stock, just keep in mind, this will be a working bar, no show, all go.
Also looking for 2x 10x5x5 go kart slick tires with rims
Thanks
need some parts
Re: need some parts
Huh? Are you sure you have a wheelstanding problem?
I've seen lots and lots of Q-scale drag cars (yes, the ones at Floyd Bennett, too) and I have NEVER seen a Q-scale race car do more than a tiny hop of a wheelstand. It's almost impossible with the cars weighing 25-plus pounds and using the small centrifugal clutches we usually use.
Are you sure it's not just for show? Come on.... I want to see this car wheelie!!!
I've seen lots and lots of Q-scale drag cars (yes, the ones at Floyd Bennett, too) and I have NEVER seen a Q-scale race car do more than a tiny hop of a wheelstand. It's almost impossible with the cars weighing 25-plus pounds and using the small centrifugal clutches we usually use.
Are you sure it's not just for show? Come on.... I want to see this car wheelie!!!
-
- 1/4 scale guru
- Posts: 404
- Joined: June 14th, 2010, 7:52 pm
Re: need some parts
Well, to be honest Mike, not really sure I will need it, but better to have it ready if need be.
Short wheel base, with a 90 on NOS, I wanna make sure I have it handy just in case.
Short wheel base, with a 90 on NOS, I wanna make sure I have it handy just in case.
-
- 1/4 scale guru
- Posts: 404
- Joined: June 14th, 2010, 7:52 pm
Re: need some parts
Thanks mike, I hope so too..