Conley Rear Ends
- stoneyberk
- Legacy Member
- Posts: 171
- Joined: September 7th, 2006, 11:54 am
- Location: Mishawaka, IN
Re: Conley Rear Ends
Wow yet another quickchange rear end to choose from... Let's see, As of two years ago the quickchange rear end was very hard to locate a used one,, now Conley / Quarter Mortar / LRU... At this rate they will be a dime a dozen in a few years... I haven't seen one first hand personally but i just hope all these guy's that's producing them has also beefed up the casing... It would be a shame to see these not pass go from the start...
Floyd's Autobody/Service Center
Custom Graphics By Design Unlimted
http://www.quarterscaleprostreetberetta.com/
Please light a candle for our dear friend '' Buddy ''
http://buddyone.pets-memories.com/
Custom Graphics By Design Unlimted
http://www.quarterscaleprostreetberetta.com/
Please light a candle for our dear friend '' Buddy ''
http://buddyone.pets-memories.com/
- Mike Casey
- Legacy Member
- Posts: 4181
- Joined: December 28th, 2004, 9:28 pm
- Location: Corona, CA
- Contact:
Re: Conley Rear Ends
Those castings are very thick. The center sections are new era and they built a very heavy duty rear. I dont think there will be issues in that department...
www.quarterscalelegends.com The Awesome history of 1/4 scale!!
Re: Conley Rear Ends
Whats the maximum car weight and engine HP you reckon they could handle before things go bad?
Just a rough figure out of curiosity.
Just a rough figure out of curiosity.
Hrem, Yes.. I see.
-
- Newbie
- Posts: 54
- Joined: December 13th, 2005, 11:26 am
- Location: MI 49343 usa
Re: Conley Rear Ends
anymore updates on this rear?
how are your projects going dreambig
i pmed you .couldnt get the reply though..
how are your projects going dreambig
i pmed you .couldnt get the reply though..
-
- Newbie
- Posts: 63
- Joined: October 4th, 2006, 8:12 pm
- Location: Baker City , Oregon
- Contact:
Re: Conley Rear Ends
They look great.
Any updates?
Any updates?
-
- 1/4 scale guru
- Posts: 404
- Joined: June 14th, 2010, 7:52 pm
Re: Conley Rear Ends
Sorry to bring back such an old thread, but am I the only one that is waiting on this???
-
- Newbie
- Posts: 54
- Joined: December 13th, 2005, 11:26 am
- Location: MI 49343 usa
Re: Conley Rear Ends
nope...