been working on a street truck chassis to go with the truck body plug ive been working on its been to cold to do any fiberglassing so ive made a start on the chassis for it ...
engine is a 39cc water cooled pocket bike engine
heres some pics
1/4 Scale Street Truck
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
Re: 1/4 Scale Street Truck
Looks good Bentley. What are you going to use for side rails. Geoff
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
Re: 1/4 Scale Street Truck
the sides will be alloy once i finished building every thing and i am happy with it i will use the wood as a template to cut them out
Re: 1/4 Scale Street Truck
Mate: I take my hat off to you, you're doing a fine job, I'm eagerly following your progress.
Kevin
Kevin
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
Re: 1/4 Scale Street Truck
not 100%sure how im going to do the rear end yet i dont think i will use the toro diffFuNkY mOnK wrote:Nice job Bentley, what's planed for the rear mount and suspension?
more than likely just use a single belt drive set up like this
-
- 1/4 scale guru
- Posts: 349
- Joined: August 5th, 2009, 1:10 pm
- Location: Hamilton New Zealand
Re: 1/4 Scale Street Truck
yeah still thinking about the rear end the motor puts out about 7hp so it will need a set up that will help with traction
allso need to put a brake on it too some where
allso need to put a brake on it too some where