www.Quarterscalelegends.com

those are really sexy.

Love the boats, keep the pix coming. Al

Check out Jay Cs Fleet here!!

Heres a few of my 45 nitro tunnel. Never been wet. the engine has seen half a litre of fuel from new and it was on the bench. yes the prop has a ding in it its off another boat.

Nicely done!

heres a couple of cats of mine, The white one is an MHZ CT-03 63 inch long. 18 inches wide at the transom. has an over hang on the rear So as I can mount my scale MTI arneson type drives to it. Has a MTI single centre mounted rudder. The big cat was pretty rough when I got it, as you can see in the last photo. I took me 2 hours of scrubbing with degreaser to get it even half clean. I removed the rails and all the crap from the previous owner. this will be powered by the 2 26cc quickdraws ( that arrived to day) with rear facing pipes. the all American I ve seince basically gave to a young bloke who had a rough start in life............BUT wait theres more.

Which do you want more of the GAS boats or the NITROS???

Jay C

Love them both!!. Do the tunnel boats have the same control issue as the 1:1 scale as far as keeping the bow from blowing over?

Al Gibson (QSL) wrote:Jay C

Love them both!!. Do the tunnel boats have the same control issue as the 1:1 scale as far as keeping the bow from blowing over?

Yes Al they but its worse in the rc version as the speeds are far greater in scale terms. Put it this way some of the guys use wheel weights to balance the boats. The rc versions even have stumble blocks under them to keep the upright in the corners. Helps stop them from barell rolling on the entry to a turn.

a few more photos

a few more to look at

3rd channel adjustable trim tabs

Sorry Gus Ive been very busy over the last few months building a new toy shop for the toys but ill be back in the shed building the boats

We look forward to your project

Just few updates