1/4 Scale Top Fuel Dragster
Posted: September 8th, 2016, 6:15 am
Hey all,
Just beginning my new 1/4 scale top fuel dragster project. I don't actually have anything done yet, but I've done some measurements, and I built a mock-up frame to make sure I had it right. From the tip of the frame to where the rear wing ends is almost 7.5 feet, so it is a little bigger than true 1/4 scale. Soon I am looking to get the tubing I need so I can start welding the frame together. Any advice would be greatly appreciated, I've never tried to do anything like this before. You can also follow the build on my Youtube channel here: https://www.youtube.com/channel/UC2xYci ... NG9idJfjuw
Thanks!
Just beginning my new 1/4 scale top fuel dragster project. I don't actually have anything done yet, but I've done some measurements, and I built a mock-up frame to make sure I had it right. From the tip of the frame to where the rear wing ends is almost 7.5 feet, so it is a little bigger than true 1/4 scale. Soon I am looking to get the tubing I need so I can start welding the frame together. Any advice would be greatly appreciated, I've never tried to do anything like this before. You can also follow the build on my Youtube channel here: https://www.youtube.com/channel/UC2xYci ... NG9idJfjuw
Thanks!