www.Quarterscalelegends.com

Ok, i tried on another site and came up basically blank
So here it is :
1/4 scale s10 pick up style truck
she weighs about 30-35lbs
go-kart tires in the rear
single speed trans(im assuming for 330 ft0
33cc McColloch eng
Heres my dilema,she runs but I need much more.Previous owner included mount plate for Zen style eng.
Any suggestions?????????

Still No photos?

Blank Ed

ok ok ooooooooooooooookay ,lol !

will post more

rear shot

side shot

Uhhh...
what's the question?

read first post !

Really? Did you realize this is the Holiday weekend?

If you are patient, you may get an answer.... How are you going to learn anything?

I met a engine builder 25 years ago....I am SURE when I first stepped into his shop
he thought I was a complete idiot, (not saying you are) but over the years I
respectfully asked questions about engines. After a while he felt comfortable enough to share all of his knowledge with me, of which I credit him for the motors we had in our race cars.

Our last motor lasted over two years, had over 900 HP and made the 1:1 car run
0 to 60 MPH in LESS than one second. ( it is still running today)
He now has respect for me too for building many race cars that run well and have lasted the test of time.

www.speeddemonracing.net

If you pay the respect these people deserve, they will be happy to help.

Learning the hard way is expensive and very frustrating.


Ed

he wants it to go faster. i bet.. first off is the motor not too favorable..

does it run good , good rpm's?

mess with carb, and pipe. see where that gets you . if not maybe a new motor., or the rear might not have the right gear ratio..

somewhere to start

I got a nice email from him.

He wants to go faster, but needs to change out the motor...


Ed

Any thoughts on where I can get a motor from? Maybe a 50-75 cc ! As stated i have the plate to mount a zen type motor.

Email sent.

Send me some specifics. I may be able to find somthing for you.


Ed

reply sent