jaguar

[frankkind]

finally can fit the body on to the schassis,looks like the wheelbase is not 680mm but myst be 700mm.
no problem schassis is adjusteble,also have to lower teh engine 12mm so id dont habe to cut the body

[frankkind]

carbon spoiler and some alloy parts replaced by carbon
DID TAKE SOME PICTURES OUTSIDE,BETTER QUALITY
going to replace the top schassis plate with carbon later

[Mike Casey]

the carbon contrasts very nice!

[frankkind]

who says cut out rear wheelarcs is not nice.
the yankee schassis has a wheelbase off 680 mm,my schassis has a wheelbase off 700mm.
than the wheel fits okay in the wheelarc.
when you look at the picture off my jag and place the rear wheel 20 mm forward,it does not fit in the arc.
also you should use the front wheels of the yankee f1,this fills the arc better
grt frank
.

[frankkind]

bumper jag finisched,now going to replace top plates schassis with carbon

[frankkind]

body mounts ready ,did change wheelbase again.
is now 710 instead yankees measerments 680mm
waiting for the carbon,whil replace top schassis parts.
carbon is easy to mill,but exspensive to buy
did ask for a complete schassis in 5 mm carbon.
two top plates and one bottomplate.
950 euro,nice price

[Mike Casey]

frank, frank, frank.... VERY NICE!! They just keep getting better. I hope you lock your doors at night

[frankkind]

thank you mike,the other stuff is delayed for one week.
whil buy another jag body and make onewith cut out rear wheelarcs and one none cut.
have to make another schassis for this,a lot of work again

[Mike Casey]

thanks for your help frank!

I cant wait to see this car with some carbon on it. The contrast will be nice. i also think the longer wheelbase is a good choice.

[frankkind]

wenn you look at the picture with the alloy wheel and place 30 mm to the front,it will look bad

[frankkind]

first carbon part ready

[Mike Casey]

ohhhhh my god!!! That is awesome!!!!!!!

[frankkind]

thank you mike.
last part off carbon made and a chain tensioner carbon alloy

[Mike Casey]

you honestly build the most amazing cars. This car is how i would imagine quarterscale if it was built today by a large rc car manufacturer like HPI or Trinity. You have an amazing vision. Thanks frank.

[frankkind]

thank you mike,now going for details,replacing all the rods by rvs 6mm rods.
looks much better.
the missing screw was a miss measerment,oops