Page 2 of 2
Re: Getting the project started again
Posted: October 1st, 2015, 5:56 pm
by garyg
Well guys here's a short clip of the engine running after ten minutes at ten thousand RPM. The hottest temp I recorded at the plug was 165. The hottest on the jugs was 135. Considering I was told I'm safe with anything under 200 I think I'll be fine. Moving on....
https://youtu.be/OCoMEETrV6w
Re: Getting the project started again
Posted: October 2nd, 2015, 1:31 am
by CALracing
Looks great but that's going to be one crowded chassi.
Re: Getting the project started again
Posted: October 2nd, 2015, 10:44 am
by garyg
Nah not really! its just two radiators more than normal. theres plenty of room.
Re: Getting the project started again
Posted: October 4th, 2015, 7:25 pm
by garyg
Here some pics of the latest progress. I modified the frame to accomadate the pipes. Fabricated the radiator mounts. I made mounts for the water and fuel tanks. I made a mount for the water pump. Last I made a mount for the coils. Everything seems to fit nicely. There's plenty of room for radio gear.
Re: Getting the project started again
Posted: October 5th, 2015, 1:30 am
by CALracing
Looks great Gary, good job.
