Page 1 of 1
new frontaxle
Posted: January 14th, 2011, 7:04 am
by frankkind
working on a new schassis,but will not make all the parts
i am going to use parts wich are on the marked
so it will be fast to make
did put some parts together for measerments off the front axle
grt frank
Re: new frontaxle
Posted: January 14th, 2011, 6:20 pm
by lowhogg2
damn frank! you do awesome work!! looks good!
Re: new frontaxle
Posted: January 16th, 2011, 11:35 am
by frankkind
yes doing some work again,not all day
got four bodies left
viper,ferari p4,jaguar,and the mclaren
got to make four shassis,but in a slow way not all days
grt frank
Re: new frontaxle
Posted: February 3rd, 2011, 11:43 am
by frankkind
made the front axsle adjusteble in hight
grt frank
Re: new frontaxle
Posted: February 5th, 2011, 7:07 am
by frankkind
frontaxsle ready,now working on the rear and schassisplate
grt frank
Re: new frontaxle
Posted: February 5th, 2011, 8:16 am
by frankkind
axsle fits perfect in the f1
grt frank
Re: new frontaxle
Posted: February 19th, 2011, 9:57 am
by frankkind
some rough cutting done for the rear axle,platic parts whil be replaced for alloy later
grt frank
Re: new frontaxle
Posted: February 19th, 2011, 10:01 am
by frankkind
behind
Re: new frontaxle
Posted: February 20th, 2011, 12:57 am
by frankkind
drive gear almost ready,fit s perfect.
gear run smoothly
grt frank
Re: new frontaxle
Posted: February 26th, 2011, 4:23 am
by frankkind
found some time to make some parts this morning
grt frank
Re: new frontaxle
Posted: March 5th, 2011, 12:17 am
by frankkind
did change the rear axle,found it to fg,also the adjusting for the rear axle done
grt frank
Re: new frontaxle
Posted: March 6th, 2011, 3:22 am
by frankkind
rear and front ready now making measerments for the schassis plat
grt
Re: new frontaxle
Posted: March 6th, 2011, 8:01 am
by frankkind
some progress on the schassis
the plate where it is on is just a plate for measering
Re: new frontaxle
Posted: March 6th, 2011, 8:17 am
by Mike Casey
Love it frank!
Re: new frontaxle
Posted: March 6th, 2011, 8:22 am
by frankkind
like it too,did stop using solidworks.
mastercam and fitting with printer drawings goes much faster.
thanks mike
grt frank