www.Quarterscalelegends.com

KO-propo pds-8044 ics 1/4 scale servo new 334 oz of torq upper o ring dry rotted off sitting in box.This was over a $125 servo when I bought it
2 1/4 scale Hitec HS-705mg steel gear used
1 Hitec HS-645MG steel gear used
2 Airtronics 94152 hightorq steel gear 105 oz 4.8 volt I had these rebuilt years ago at airtronics have not used them since that cost me $92
all the above servos where tested a few years back
misc servos
futaba 9301
futaba s148
airtronics 94102
hitec z550 three of them
a pile of on and off switches
$100 plus shipping for all
Tiny turbo charger for charging receiver packs charges 4 to 8 cells rate adjustable from .05 to 75 amps uses 12to 18 volt supply $20 plus shipping

For sale s used Hobbico Pro Series Accu-Cycle is a digital battery charger/conditioner/analyzer designed for nickel-cadmium (NiCd) and
nickel-metal hydride (NiMH) radio control transmitter, receiver and individual batteries. It can independently charge,
discharge, or cycle receiver and transmitter batteries at the same time. The Accu-Cycle provides valuable information about
the condition of each battery through two easy to read liquid crystal displays (LCD).
The Accu-Cycle uses an internal timer to automatically switch from a constant charge rate over to trickle charge after 15 hours.
The Accu-Cycle automatically terminates discharge when your battery voltage drops to a predetermined value. After
discharge is complete, the Accu-Cycle will automatically switch back to the charge mode, recharging your batteries so they
are ready for use. Your battery’s discharge data will remain on the display after discharge is complete for your convenience.$ 20 plus shipping

Take all for servos and chargers for $100 plus shipping

bump

$100 shipped

I have a couple of questions. How can I reach you as I am unable to send you a PM.

Interested. Send me a PM. I am a new member and can not PM your directly.