RC4WD QC rear with 1/2 in axle
Posted: April 1st, 2018, 1:56 pm
This is a "prototype" RC4WD rear. I converted it to a 1/2 inch axle
So it would fit in a grand national car. It needs to be refined some still to be able to drive a car with it installed. It will be fine if you want it for a shelf queen car. No guarantee but I believe I have all the parts to convert it back to its original condition if you want them.
$400.00 plus shipping
So it would fit in a grand national car. It needs to be refined some still to be able to drive a car with it installed. It will be fine if you want it for a shelf queen car. No guarantee but I believe I have all the parts to convert it back to its original condition if you want them.
$400.00 plus shipping