Page 1 of 1
Wheels for a -34 project
Posted: November 24th, 2018, 3:50 pm
by Bikerbuz
Looking for a set of complete wheels for my -34 Roadster project. Either a pair of aluminum rear wheels (6 studs) which at least somewhat match the centerline type front wheel in the picture or a full set of some other type, aluminum or stamped steel, that fit the RC4WD knock off hubs. The offset isn't that important. I can always cut the rear axle to fit the wheels.
Though I would rather not have the type that was on ebay a little while ago, where the front wheels are so small, they don't even look like they're meant for a 1/4 scale car. Tell me what You have and I'll get back to You as soon as I can.
Please don't get bummed if I don't answer posts or PM's right away. I don't get notifications about new posts or PM's, so it might take a day or so before I see them.
Re: Wheels for a -34 project
Posted: January 13th, 2019, 11:57 am
by Bikerbuz
Got wheels, so I'm good for a while now.