www.Quarterscalelegends.com

hello , I am laurent the new boss of Yankee

The projects are many and the passion always !

I do everything I can to continue has to make live the legend of 1/4 scale models.

Respectfully,

Laurent

welcome to the site!!!

Did you acquire a lot of parts and tooling?

Many tools are saved , all plastics injection molds .

A big part of the molds of body , jaguar LM , Porsche , P4 330 , GT 40 , calibra DTM , F1 Benetton , Cross control 1/6 , Twingo , Spider 905 ...

905 LM will be available in 1 or 2 month !

see on the shop new production in ABS bodies (p4 330 , Twingo , and GT 40 Available at the end of the week ).

Hello and thank you for your order ,

Yankee is in full change but we make very attention to respect historic made.

We are now a small structure and we shall be happy to receive you !

Your parcel is ready and leaves with all the necessaires protections tomorrow.

Hy Emilio !

Thank you for your post .

to cuting the P4 body , my advice :

- first cut the body
- after for the wheel use a compass for lexan for a 200mm diameter hole , the good distance for the center is :

123mm from the vertical line behind the front wheel (front center)

467mm from the vertical line behind the front wheel (rear center)

- be careful with the side stays for drill the 4 holes compare the 2 parts , adjust the body position .

Laurent

I post a topic with pic for the cutting :


http://www.quarterscalelegends.com/bb/v ... =20&t=3610